Meade ETX Astro Telescope/ETX Spotting Scope Instruction Manual download pdf (Page 31)

MEADE LIMITED WARRANTY

Every Meade telescope, spotting scope, and telescope accessory is warranted by Meade Instruments Corporation (“Meade”)

to be free of defects in materials and workmanship for a period of ONE YEAR from the date of original purchase in the U.S.A.

and Canada. Meade will repair or replace a product, or part thereof, found by Meade to be defective, provided the defective

part is returned to Meade, freight-prepaid, with proof of purchase. This warranty applies to the original purchaser only and is

non-transferable. Meade products purchased outside North America are not included in this warranty, but are covered under

separate warranties issued by Meade international distributors.

RGA Number Required: Prior to the return of any product or part, a Return Goods Authorization (RGA) number must be

obtained from Meade by writing, or by calling (949) 451-1450. Each returned part or product must include a written statement

detailing the nature of the claimed defect, as well as the owner’s name, address, and phone number.

This warranty is not valid in cases where the product has been abused or mishandled, where unauthorized repairs have been

attempted or performed, or where depreciation of the product is due to normal wear-and-tear. Meade specifically disclaims

special, indirect, or consequential damages or lost profit which may result from a breach of this warranty. Any implied

warranties which cannot be disclaimed are hereby limited to a term of one year from the date of original retail purchase.

This warranty gives you specific rights. You may have other rights, which vary from state to state.

Meade reserves the right to change product specifications or to discontinue products without notice.

This warranty supersedes all previous Meade product warranties.

WARNING

This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions contained in this manual, may cause harmful interference to radio and television

communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that of the receiver.

• Consult the dealer or an experienced audio/television technician.

Note: Connecting this device to peripheral devices that do not comply with CLASS B requirements or using an unshielded

peripheral data cable could also result in harmful interference to radio or television reception.

The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate this equipment.

To ensure that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.

1 2 ... 26 27 28 29 30 31 32

No comments

Meade ETX Astro Telescope/ETX Spotting Scope Instruction Manual Page 31