Meade TS33F-M User's Guide download pdf (Page 30)

RFXtrx Version 5.06 page 30 / 39

8. Blyss commands

Some Blyss devices, like the Blyss motors, require a special command sequence number. To

simplify it; 0,1,2,3,4,0,1,…

This sequence number is normally created by the Blyss remote but now also by the RFXtrx433.

If you use a Blyss remote and the application (Domoticz, DomotiGa, Homeseer…) does not sync

with the received Blyss command you will see that you need to send multiple commands with the

RFXtrx433 before the Blyss device will respond.

For example,

The Blyss remote transmits with the sequence numbers 0,1,2

If the RFXtrx433 transmits now with sequence number 0 it will not be seen by the Blyss device as

a valid command and at the time the RFXtrx433 transmits the commands 1,2,3 the command will

be detected as valid when it receives the command with sequence number 3.

The same is true for the remote. If you transmit commands with the RFXtrx433 and after that with

a Blyss remote you need to transmit several commands with the remote before the Blyss device

responds.

I guess the same behaviour will show if you use multiple Blyss remotes.

9. How to find the dx.com RGB LED strip driver ID

Valid for the TRC02 remote with 2 batteries.

Flash the RFXtrx433 with Type2 firmware to be able to receive the remote ID in RFXmngr.

In RFXmngr enable only the LightwaveRF (AD) protocol.

------------------------------------------------

Packettype = Lighting5

subtype = RGB TRC02

Sequence nbr = 5

ID = FCC48B

Command = On

Signal level = 8

The ID is: FC C4 8B

If necessary flash the RFXtrx433 back to Type1 if Type2 does not support devices you need. (See

chapter 2.2)

10. How to find the dx.com RGB LED strip driver ID (rev. 2)

Valid for the TRC02 remote with 3 batteries.

In RFXmngr enable only the Lighting4 protocol.

------------------------------------------------

Packettype = Lighting4

subtype = PT2262

Sequence nbr = 29

Code = 161C84

The ID is: 16 1C

11. How to find the Eurodomest ID

You can assign a random ID to the Eurodomest. If you want to use the same ID as the remote you

can find the ID of the remote using RFXmngr.

Start RFXmngr and enable only the Lighting4 protocol.

Press a button on the remote and you will receive a message like:

------------------------------------------------

Packettype = Lighting4

subtype = PT2262

Sequence nbr = 12

Code = 6DFE0F

The ID is: 6 DF E0

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Comments to this Manuals

No comments

Meade TS33F-M User's Guide Page 30

Comments to this Manuals

Related products and manuals for Thermostats Meade TS33F-M