Meade TE688W User Manual download pdf (Page 9)

H. UP (? ) button

• Press to select the next available mode

• Increase the parameters

• In time with seconds display mode, press and hold for 2

seconds to activate/ deactivate radio controlled time signal

search manually.

• In time with weekday display mode, press and hold for 2

seconds to switch time zone from Pacific, Mountain, Central to

Eastern.

I. MEM/ HISTORY button

• When temperature mode has been selected, press to recall the

minimum or maximum temperature and humidity readings of

main and remote units.

• Press and hold for 2 seconds, collected memories will be

cleared.

• When pressure mode has been selected, press once to check the

historical pressure data for the past 24 hours.

J. WALL- MOUNT hole

• A recessed opening to mount the unit on a wall

K. BATTERY COMPARTMENT

• Requires two (2) UM-3 or AA 1.5V alkaline batteries

L. TABLE STAND

BATTERY INSTALLATION

• Remove the battery door located at the back of the main unit.

• Insert two (2) AA size batteries according to the polarities

shown and replace the battery compartment door.

• When placing the main unit on the table or other horizontal

surface, unfold and adjust the table stand for the desired

viewing angle.

PLACEMENT

• Make sure that the main unit is locating within the operating

range of all remote sensors.

• Ideally the main unit should be placed within line of sight of

remote sensors. Avoid placing the main unit where surfaces

emitting and radiating heat (e.g. heating ducts or air

conditioners) and areas with interference from wireless devices

(e.g. cordless phones, radio headsets, baby monitoring devices

and other electronics).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Meade TE688W User Manual Page 9